Marker Generator Calibrator 10MHz 1MHz 100KHz with OCXO 5V BNC

Description: Item Description: For sale today is one calibrator with 100KHz, 1MHz, and 10MHz outputs. The three outputs are 2.5V square waves into 50 ohms, 5V into a high impedance load. The reference oscillator is a 5V Oven Controlled Crystal Oscillator (OCXO). The board will be calibrated against a GPSDO to better than 0.1Hz at 10MHz. It will be within 1Hz@10MHz after about 3 to 5 minutes and to better than 0.1Hz after about 10 to 15 minutes. The BNC connectors are genuine AMP connectors. Nuts and washers are supplied for the BNC connectors. The 10MHz can also be used as a reference for a frequency counter. Do not connect this directly to a radio antenna input. The board is 2.9" by 2.1". The 2.9" dimension is along the BNC side of the board. The BNCs are spaced 1" apart. The board will fit in a Hammond 1455K1201 or 1455K1202 enclosure (not included) or can be mounted anywhere it will fit using the four mounting holes. Power is 5V at 400mA at startup and 240mA when the OCXO is at temperature. Condition: This is a new hand assembled PCB with a used OCXO. PayPal Confirmed Address: PayPal address must be confirmed and must be the same as the shipping address.Returns: All items are sold as-is unless otherwise stated. Returns: Returns accepted within 30 days. Feedback: Feedback is important to me, please email or contact me with any concerns, issues or problems before leaving feedback and give me the opportunity to work things out if needed. I always leave positive feedback after receiving feedback from the buyer, that way I know the buyer is happy and the transaction is complete. Shipping: Shipping is to USA only.

Price: 39 USD

Location: New Hartford, Connecticut

End Time: 2024-08-09T19:25:29.000Z

Shipping Cost: N/A USD